Cycle Accessory Store

ROKKER THE world’s most powerful 4-ch amplifier for your Harley Bagger audio system

This exciting new J&M 4-channel 500w fairing speaker amplifier kit has been design specifically for use in the 2006-Now Harley® StreetGlide with the Harley HK radio, with 2 extra speakers (total of 4) mounted in either the lower fairing position or inside the saddlebags.  This is a full range class G amplifier and is spec’d at 125watts RMS per channel X4 channels, (500w total) driven continuous into a 2 ohm load @ 14.4vdc, 70watts RMS continuous X4 channels into a 4 ohm load.

Amplifier mounts to the top of the custom made stainless steel bracket system, which has the slots in the bottom section to properly relocate 2 of the Harley CB, MP3 or XM sat radio modules, if installed.  The specific plug-n-play wiring harness included with this kit, takes the 2-channels of audio signal available from the Streetglide version of the Harley HK radio, and provides 4 separate channels of amplification at 125w RMS continuous for each channel.

Custom made plug-n-play wiring harnesses are included with this amplifier kit, top quality heavy gauge power/ground wires are used for the fused battery connection, along with all necessary mounting hardware & complete installation/operation instructions.

Amplifier itself measures 10 5/8” Long X 5” Wide (widest point) X 1 5/8” Tall.

Combines the BT444 or BT 454 Titan Amplifier with the Hertz Hi-Energy 6 1/2" 200W Speakers.

Amplifier Description

Hertz Hi-Energy 6 1/2" 200W Speakers Description

• 6 1/2" Speakers = ultimate speaker upgrade - 153% over Harley™ stock!!
• No modifications required - bolt in, plug-in and go!
• 5 1/4" to 6 1/2" speaker adapters
• Free-flow grill design ensures maximum sound transfer
• High quality glass-reinforced nylon adapters
• Complete with mounting hardware
• 100 watts RMS / 200 watts peak

*Pre-2006 RoadGlides must be updated to newer style grill assembly, parts available for purchase through most local Harley dealerships, PN: 77021-98B and 77022-98B. 

This exciting new J&M 250w fairing speaker amplifier kit has been design specifically for use in the 2006 - Now Harley® RoadGlide fairing, with the Harley HK radio. (may also work with the 1998-2005 Harley RoadGlide fairing/radio, under the certain conditions mentioned in "Extended Description")

This is a full range class G amplifier and is spec’d at 125watts RMS per channel, both channels driven, continuous into a 2 ohm load @ 14.4vdc, 70watts RMS continuous into a 4 ohm load.

Amplifier mounts to the custom made metal mounting bracket system.

Custom made plug-n-play wiring harnesses are included with this amplifier kit, top quality heavy gauge power/ground wires are used for the fused battery connection, along with all necessary mounting hardware & complete installation/operation instructions.

Amplifier itself measures 7 ¼” X 4 ¾“ X 1 ¾”.

 6 1/2" Speaker Upgrade for Harley Ultras,Classics,Standards,Tri-Glides, Street Glides and RoadGlides!

J&M’s new 7 ¼” round subs are the largest diameter speakers that can be installed into the Harley® RoadGlide style fairing, with cone volume and mass comparable to a 6X9” speaker.

This new two-way high-performance speaker set has been designed specifically for the 2006 - Now Harley RoadGlide fairing.

Spec’d at 2 ohms impedance and 140+ watts max power, these new speakers provide the ultimate in bass response, extended mid/high frequency range and raw audio power.

J&M’s new 7 ¼” round subs are the largest diameter speakers that can be installed into the Harley BatWing style fairing, with cone volume and mass comparable to a 6X9” speaker. This new two-way high-performance speaker set has been designed specifically for the 2006-Now Harley® Ultra/Street/Electra Glide fairing. Spec’d at 2 ohms impedance and 140+ watts max power, these new speakers provide the ultimate in bass response, extended mid/high frequency range and raw audio power.